Filter
Top Products
Problems and remedies (continued)
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CO will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is loaded label side down.
• There is moislure on the CD.
Play does not start from the first track.
• The player is in program or shu file mode. Press
PLAY MODE repeatedly until "PGM" or
"SItUF" disappears.
The disc tray does not open and "LOCKED"
appears.
• Contact your Sony dealer or local authorized
Sony service facilily.
Tape Deck
The tape does not record.
• NO tape in the cassette holder.
• The tabhas been removed from the cassette (see
"To save a tape permanently" on page 27).
• The tape has reeled to the end.
The tape does not record nor play or there is a
decrease in sound level.
• The heads are dirty (see "Cleaning the tape
heads" on page 28).
• The record/playback heads are magnetized (see
"Demagnelizing the tape heads" on page 28).
The tape does not erase completely.
• The record/playback heads are magnetized (see
"Demagnelizing the tape heads" on page 28).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers arc dirty (see
"Cleaning the tape heads" on page 28).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized (see
"Demagnelizing the tape heads" on page 28).
Tuner
There is severe hum or noise ("TUNED" or
"STEREO" flashes in the display).
• Adjust the antenna.
• The signal strength is too weak. Connect the
external antenna.
A stereo FM program cannot be received in
stereo.
• Press STEREO/MONO on the remote repealedly
until "MONO" disappears.
If other troubles not described above
occur, reset the system as follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press I, GROOVE, and I/(_ at the same
time.
4 Press Ig@ to turn on the system.
The system is reset it) the factory settings. All
the settings you made are cleared.
One of the fbllowing messages may appear or
flash in the display during operation.
NO DISC
• There is no CD on the disc tray.
OVER
• You have reached the end of the CD.
"PROTECT" and "PUSH POWER" appear
alternately.
• A strong signal was input. Press I/(_3 to turn off
the system, leave the system mined off tbr a
while, then press I/([) again to turn on the
system. If"PROTECT" and "PUSH POWER"
appear alternately even at}er the system is turned
on again, press I/(_ Io turn offthe syslem and
check the speaker cord.
26 GB