Filter
Top Products
23
EN
Editing Recorded MDs
Undoing the Last Edit (Undo
Function)
You can use the Undo Function to cancel the last edit
and restore the contents of the MD to the condition that
existed before editing was done. Note, however, that
you cannot undo an edit if you do any of the following
after the edit:
• Press the r REC button on the deck.
• Update the TOC by turning off the deck or ejecting
the MD.
• Disconnect the AC power cord.
1 With the deck stopped and no track number
appearing in the display, press EDIT/NO
repeatedly until “Undo ?” appears in the display.
“Undo ?” does not appear if no editing has been
done.
2 Press YES.
One of the following messages appears in the
display, depending on the type of editing to be
undone:
Editing done: Message:
Erasing a single track
Erasing all tracks on an MD “Erase Undo ?”
Erasing a part of a track
Dividing a track “Divide Undo ?”
Combining tracks “Combine Undo ?”
Moving a track “Move Undo ?”
Labeling a track or an MD
“Name Undo ?”
Erasing all titles on an MD
3 Press YES again.
“Complete” appears for a few seconds and the
contents of the MD are restored to the condition
that existed before the edit.
To cancel the Undo Function
Press EDIT/NO or p.
Erasing all titles on a disc (Name Erase)
Use this function to erase all titles on an MD
simultaneously.
1 While the deck is stopped, press EDIT/NO
repeatedly until “All Erase ?” appears in the
display.
2 Press EDIT/NO again.
“Name Erase ?” appears in the display.
3 Press YES.
All titles are erased.
To cancel the Name Erase Function
Press p.
z You can undo the Name Erase Function
See “Undoing the Last Edit” on this page.
z You can erase all recorded tracks and titles
See “Erasing all tracks on an MD” on page 18.
≠ ±
Pp
0)
r
·
§
EDIT/NO YES