Filter
Top Products
48
US
HT-6600DP 4-244-560-11(1) US
Specifications (continued)
Supplied accessories
FM wire antenna (1)
AM loop antenna (1)
Speaker connecting cord, long (2)
Speaker connecting cord, short (3)
Monaural connecting cord (1 phono to 1 phono) (1)
Coaxial digital cord (1)
Foot pads (speakers) (20)
Foot pads (subwoofer) (4)
Remote commander (1)
R6 (size -AA) batteries (2)
Speakers
• Front speakers (2)
• Surround speakers (2)
• Center speaker (1)
• Sub woofer (1)
For details on the area code of the component you
are using, see page 4.
Design and specifications are subject to change
without notice.
SA-WMSP85 for sub woofer
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, from 28 – 200 Hz;
rated 100 watts, minimum RMS power, with no
more than 0.8% total harmonic distortion from
250 milliwatts to rated output (Models of area
code U only).
Speaker system Active subwoofer,
magnetically shielded
Speaker unit Woofer: 20 cm cone type
Enclosure type Acoustically loaded bass
reflex
Continuous RMS power output
(6 ohms, 20 – 250 Hz)
100 W
Reproduction frequency range
28 Hz – 200 Hz
High frequency cut-off frequency
150 Hz
Input LINE IN (input pin jacks)
Power requirements
Area code Power requirements
U, CA 120 V AC, 60 Hz
Power consumption 100 W
Dimensions (w/h/d) Approx. 10 3/4 × 12 7/8 ×
15 3/4 inches including
front panel
Mass 22 lb 1 oz