Filter
Top Products
23
Optional Components/Additional Information
continued
Additional Information
Precautions
The nameplate is located on the bottom exterior.
On safety
• The glass over the display window on the cover is
made of tempered glass.
Under normal conditions, this tempered glass is
more shock resistant and able to bear more weight
than ordinary glass. This glass, however, may
shatter if it receives a sharp blow or if it is
scratched.
• The system is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the system itself has been turned off.
• Unplug the system from the wall outlet if it is not to
be used for an extended period of time. To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
system, unplug the system and have it checked by
qualified personnel before operating it any further.
• The AC power cord must be changed only at the
qualified service shop.
• When you connect the AC power cord to the wall
outlet (mains), even though the power is off, the
system begins charging for remote and timer
functions. Therefore the surface of this unit
becomes warm, this is normal.
On placement
• Make sure the system fan is on during use. Place the
system in a location with adequate air circulation,
and do not place anything on the system.
• Place the system in a location with adequate
ventilation to prevent heat build up.
• Do not place the system in an inclined position.
• Do not place the system in locations where it is;
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight.
On installing
When you move the system, remove the CD.
Important
If you connect an external antenna, connect the
ground wire and the AM antenna to the U terminal.
To prevent a gas explosion, do not connect the ground
wire to a gas pipe.