Filter
Top Products
10
Listening to the radio
Preset radio stations in the tuner’s memory first
(see page 7). To turn on the system, press "/1.
?/1
NX x .
m
M
>
VOL –/+TUNER/
BAND
./>
TUNING –/+
Z
VOL +/–
1
2
3
STEREO/
MONO
"/1
(Power)
"/1 (Power)
To Do this
Stop play Press x.
Pause Press NX (or S on the
remote). Press again to
resume play.
Select a track Press ./> repeatedly
until you find the desired
track.
Find a point in
a track
Press and hold m/M
during play, and release it at
the desired point.
Remove CD Touch Z (or press OPEN/
CLOSE on the remote).
Adjust the volume Press VOL +/–.
Tips
• You can switch from another source to the CD
player and start playing a CD by pressing NX (or
CD H on the remote) (Automatic Source
Selection).
• If you press NX (or CD H on the remote) while
the power is off, the power turns on and play starts
automatically (One Touch Play).
• If you touch Z while the power is off, the power
turns on, the function switches to CD, then the disc
tray rises automatically.
• To listen through the headphones, connect the
headphones to the PHONES jack on the rear panel.
Notes
• Do not forcibly press the disc down with your
finger, as this may cause CD player trouble.
Furthermore, do not obstruct the ejecting CD. Be
sure to touch Z (or press OPEN/CLOSE on the
remote) to lower the disc tray.
• Do not push strongly on Z, as this may damage the
player.
• The disc tray will not operate if you touch Z while
wearing gloves. Touch Z with bare hands or press
OPEN/CLOSE on the remote.
Playing a CD (continued)