Filter
Top Products
Basic Operations
11
To cancel the Automatic Tuning
Press TUNING MODE.
Tips
• You can switch from another source to the tuner by
pressing TUNER/BAND (Automatic Source
Selection).
• If you press TUNER/BAND while the power is off,
the power turns on and the system tunes in the last
received station automatically (One Touch play).
• To improve broadcast reception, reorient the
supplied antennas or connect an optional external
antenna.
• When an FM program has static noise, press
STEREO/MONO until “MONO” appears. There
will be no stereo effect, but the reception will
improve. Press again to restore the stereo effect.
1 Press TUNER/BAND repeatedly until
the band you want appears.
Each time you press the button, the band
changes as follows:
FM y AM
AUTO
TUNED
STEREO
MHz
2 Press TUNING MODE repeatedly until
“PRESET” appears.
PRESET
TUNED
STEREO
MHz
3 Press l/L to select the desired
station’s preset number.
PRESET
TUNED
STEREO
MHz
To Do this
Turn off the radio Press "/1 to turn off the
system.
Adjust the volume Press VOL +/–.
To listen to non-preset radio
stations
• Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
+/– (or TUNING +/– on the unit) repeatedly to
tune in the desired station (Manual Tuning).
• Press TUNING MODE repeatedly until
“AUTO” appears in step 2, then press
+/– (or TUNING +/– on the unit). The
frequency indication changes and scanning
stops when the system tunes in a station
(Automatic Tuning).