Filter
Top Products
14
GB
Checking the Supplied
Accessories
Remote control (1)
AC adaptor (1)
AC power cord (1)
Network (LAN) cable (1)
CD-ROM (“Network Speaker Wi-Fi Utility”)
(1)
Operating Instructions (this manual)
Preparations for listening to music via your
home network (Leaflet)
Preparing the Unit and
the Remote Control
1
Connect the AC power cord to
the AC adaptor.
2 Plug the connector of the AC
adaptor into the DC IN terminal
on the unit.
3 Plug the AC power cord to a
wall outlet (the mains).
To use this unit all in wireless
The unit is charged automatically when you
connect the unit to an AC power source. You
can use the unit without connecting the AC
power cord. Charging time depends on what
mode the unit is in. Refer to “Charging time:”
(page 37).
Notes
• Depending on the unit temperature, you may be
unable to use the unit or the power may turn off
automatically to protect the unit. If temperature is
too high, leave the power off and wait until the unit
temperature goes down. If you turn on the power
without letting the unit cool sufficiently, the power
may turn off again or you may be unable to operate
the unit.
• If you charge the unit after it has not been used for
a long time, you may be unable to charge it to the
proper capacity the first time. This is due to the
battery characteristics, and is not a malfunction.
Charge the unit again.
The supplied lithium battery (CR2025) has
already been inserted into the remote control.
Pull out the protective sheet before use.
Connecting to an AC power
source
Preparing the remote control