Filter
Top Products
10
GB
Rear
H WPS button
Use to make the network settings for the
WPS push button configuration (page 16).
I DC IN terminal
Use to connect the supplied AC adaptor
(page 12).
J AUDIO IN terminal
Use to connect the audio output jack of an
external component.
K (LAN) port
Use to connect the network (LAN) cable.
L Power switch
Slide the switch to turn the power on or off.
Note
You cannot operate this unit via a home network
when the power switch is set to OFF. Set the unit
to the network standby mode when you want to
operate the unit via a home network. Refer to
“To set the network standby mode” (page 13).
M ALL RESET button
Press and hold for more than three seconds
to reset the unit to its factory default
settings when the power switch is set to
ON.
Use a thin object, such as a small pin.
The bookmark list (page 24) and any other
previously registered settings or
information will be reset.
Note
Network settings are also reset when you press
ALL RESET button.
ALL RESET
button