Sony RDHGTK1I Stereo System User Manual


 
model name [FST-GTK2i]
[4-186-872-11(2)] GB
23
GB
Additional Information
filename[D:\NORM'S JOB\SONY HA\SO0098\G-
Tank_PMRF\4186872112_GB\GB07ADD.fm]
masterpage:Right
Precautions
On safety
Completely disconnect the power cord (mains
lead) from the wall socket (mains) if it is not
going to be used for an extended period of
time. When unplugging the unit, always grip
the plug. Never pull the cord itself.
Should any solid object or liquid get into the
system, unplug the system, and have it
checked by qualified personnel before
operating it again.
(For customers in United States and Canada
only)
One blade of the plug is wider than other for
the purpose of safety and will fit to the wall
outlet only one way. If you are unable to insert
the plug fully into the outlet, contact your
dealer.
The AC power cord can be changed only by a
qualified service facility.
On placement
Do not place the system in an inclined
position or in locations that are extremely hot,
cold, dusty, dirty, or humid or lacking
adequate ventilation, or subject to vibration,
direct sunlight or a bright light.
Be careful when placing the unit or subwoofer
on surfaces that have been specially treated
(for example, with wax, oil, polish) as staining
or discoloration of the surface may result.
On heat buildup
Heat buildup on the unit during operation is
normal and is not a cause for alarm.
Do not touch the cabinet if it has been used
continuously at a high volume because the
cabinet may have become hot.
Do not obstruct the ventilation holes.
On the speaker system
This speaker system is not magnetically
shielded, and the picture on nearby TV sets may
become magnetically distorted. In this situation,
turn off the TV, wait 15 to 30 minutes, and turn
it back on. If there is no improvement, move the
speakers far away from the TV.
Cleaning the cabinet
Clean this system with a soft cloth slightly
moistened with a mild detergent solution.
Do not use any type of abrasive pad, scouring
powder, or solvent, such as thinner, benzine,
or alcohol.
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
RDH-GTK1i USA model only
With 6-ohm loads, both channels driven,
from 120 Hz – 10 kHz; rated 30 watts per
channel minimum RMS power, with no
more than 0.7% total harmonic distortion
from 250 miliwatts to rated output.
Amplifier section
FST-GTK2i
The following are measured at
AC 127 V, 60 Hz
Front speaker:
Power Output (rated)
35 W + 35 W (at 6 :, 1 kHz, 1% THD)
RMS output power (reference)
110 W + 110 W (per channel at 6 :,
1 kHz)
Subwoofer:
RMS output power (reference)
230 W (8 :, 100 Hz)
FST-GTK1i and RDH-GTK1i
North American model only
The following are measured at
AC 120 V, 60 Hz
Front speaker:
RMS output power (reference)
110 W + 110 W (per channel at 6 :,
1 kHz)
Continued
l