Filter
Top Products
38-GB
Connecting to a stereo system
Connect the i jack of the recorder to the LINE IN jacks of an
amplifier or a tape recorder with a line cable (not supplied). The
output is analog. The recorder plays the MD digitally and sends
analog signals to the externally connected equipment.
When the recorder is connected to an another
audio component through the supplied remote
control.
When connecting a line cable (not supplied) to the headphones/
earphones jack of the remote control, be sure to set the “BEEP”
setting to “BEEP OFF.” This keeps the beep sound out of the
recorded signal or the output from the externally connected
equipment.
1 Press MENU, press <SELECT, repeatedly until “BEEP”
flashes in the display, and then press ENTER.
2 Press <SELECT, repeatedly until “BEEP OFF” flashes in
the display, and then press ENTER.
To turn on the beep sound
Select “BEEP ON” in step 2.
Portable DAT
recorder, etc.
Stereo system,
etc.
to LINE IN
2 phono plugs
L (white)
Stereo
mini-plug
R (red)
Line cable
(not supplied)
Line cable
(not supplied)
to i