Filter
Top Products
Message Case and/or corrective action
RECONNECT USB
You tried to operate the recorder or the computer before the recorder was
recognized by the computer. Reconnect the USB cable.
REHEARSAL
You tried to operate on the remote while performing the Divide Rehearsal
function (
page 47). Do the setting on the recorder.
SORTING
The recorder is sorting information after you selected “Artist” or “Album”
in the play mode.
SOUND
You operated the recorder while setting the Sound function (
page 45) on
the remote. Do the setting on the remote.
STANDBY
This message appears when the recorder, while connected to the
computer, has written data to the disc once and is ready to write data again
immediately. If you try to write data to the disc while “STANDBY” is not
displayed, it may take a little time for writing to begin.
SystemFILE
WRITING
The recorder is storing information (track start and end position) from the
memory to the disc (
page 80). Wait until this process is completed.
TEMP OVER REC STOP
Heat has built up in the recorder. Let the recorder cool down.
TitleFULL
You tried to enter characters that exceeds the maximum number
(approximately 200 characters) for a title.
You tried to enter characters that exceeds the maximum number
(approximately 55,000 characters in Hi-MD mode or 1,700 characters in
MD mode) for a disc.
TOC DATA ERROR
The recorder cannot read the disc information correctly. Insert another disc.
TRACK FROM PC NO
EDIT
You tried to combine or divide tracks that were transferred from the
computer or recorded in Hi-MD mode using the MD Simple Burner
software.
TRACK FROM PC NO
REC
You tried to record in the middle of a protected track that has been
transferred from the computer or you tried to record in the middle of a track
that was recorded in Hi-MD mode with the MD Simple Burner software.
TRACK FULL
You tried to record more than 2,047 (on a disc used in Hi-MD mode) or 254
(on a disc used in MD mode) tracks. Erase unnecessary tracks (
page
54).
74
MZ-RH1/MZ-M200.GB.2-669-084-11(1)