Filter
Top Products
Symptom Case and/or corrective action
Recording cannot be done
correctly.
Audio sources may not be securely connected. Disconnect the
audio sources once and connect them again (
pages 31, 37).
There is no digital signal from the portable CD player. When
recording digitally from a portable CD player, use the AC power
adaptor and disable the anti-skip function (such as ESP) on the
CD player.
The analog recording was made using a connecting cord with an
attenuator. Use a connecting cord without an attenuator (
page
11).
Recording level is too small to record (when adjusting the
recording level manually). Pause the recorder and adjust the
recording level (
page 52).
The recorder is connected to the computer. Disconnect the
recorder from the computer when recording.
The power sources was disconnected or a power outage occurred
during recording. The recording result is not recorded on the disc.
Make recording again.
Recording may not be done if the remaining recordable time on
the disc is 48 seconds or less (“DISC FULL” appears). Replace
the disc.
The lid does not open after
recording.
The lid does not open until “SystemFILE WRITING” disappears
in the display.
“TRACK FULL” appears even
before the disc has reached the
maximum recording time and the
recording cannot be done.
This occurs due to the limitation of the system. When 2,047 tracks
(on a disc used in Hi-MD mode) or 254 tracks (on a disc used
in MD mode) have been recorded on the disc, “TRACK FULL”
appears regardless of the total recorded time. More than 2,047
tracks or 254 tracks cannot be recorded on the disc. To continue
recording, erase unnecessary tracks.
The remaining recording time does
not increase even after erasing
numerous short tracks.
This occurs due to the MiniDisc system limitation (in MD mode
only). Tracks of under 12 seconds (in SP mode), 24 seconds (in
LP2 mode or monaural), or 48 seconds (in LP4 mode) in length
are not counted and so erasing them may not lead to an increase in
the recording time.
66
MZ-RH1/MZ-M200.GB.2-669-084-11(1)