Filter
Top Products
60
While Editing
No sound comes
through the
headphones/
earphones.
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i.
• The plug is dirty.
, Clean the plug.
The recorder skips
to several tracks
ahead or behind
when you press
. or > on
recorder.
• The GROUP button has been pressed ( is flashing in the
display).
, The recorder returns to normal if no operation has made for 5
seconds.
The edited tracks
may exhibit sound
dropout during
search operations.
• This occurs due to the MiniDisc system limitation. The
fragmentation of data may cause sound dropout while searching
because the tracks are played in higher speed than normal
playback.
R-channel sound is
not output when
playing a track
recorded from a
cassette deck or an
amplifier, or when
listening a track
with connected
cassette deck or
through an
amplifier.
• R-channel sound is not output if connecting to a cassette deck or an
amplifier with a monaural cord.
, Make sure to use a stereo connecting cord. However, if the
connected equipment is a monaural specification, R-channel
sound will not be output even if connecting with stereo
connecting cord.
Symptom Cause/Remedy
The lid does not
open.
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
Editing could not
be done.
• The power sources have been disconnected or a power outage
occurred while editing.
, Editing result up to that point is not recorded on the disc. Do
the editing operation again
The tracks that are
checked out from
your computer
cannot be erased.
• This is due to the MiniDisc system limitations. To erase a track that
has been checked out from your computer, check it back in first,
and then erase it using the SonicStage software.
Symptom Cause/Remedy