Filter
Top Products
35-GB
Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
BLANK • An MD with no recording on it is inserted.
, Insert a recorded MD.
ERROR • The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. If this fails, rerecord.
FULL • There is no more space to record on the disc (less than 12
seconds in stereo, 24 seconds in LP2 mode or monaural or 48
seconds in LP4 mode available).
, Replace the disc.
Saving • The MD player is recording information (sounds) from the
memory to the disk.
, Wait until this process is completed. Do not expose the
player to any physical shock, nor disrupt power supply.
Edit • The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the
player to physical shock, nor disrupt power supply.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take
2–3 minutes).
FULL • You tried to enter more than 200 letters to label a single track
or disc.
• You tried to enter a total of more than 1,700 letters for track or
disc names during playback or stop.
, Enter the characters within the limit.
HiDCin • Voltage of the power supply is too high (The recommended
AC power adaptor is not used).
, Use the recommended AC power adaptor.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 23).
LoBATT • Battery is weak.
, Replace the dry battery (page 9).
MEMORY • You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording
again.