Filter
Top Products
25-GB
Editing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
• Do not move or jog the recorder while “Edit”
is flashing in the display.
• You cannot edit tracks on an MD that is
record-protected. Before editing tracks, close
the tab on the side of the MD (page 31).
• If you perform an editing operation while
playing, be sure not to turn the power off until
“Edit” disappears in the display.
• The lid does not open until “Edit” disappears
in the display after editing.
Erasing tracks
To erase a track
Note that once a recording has been
erased, you cannot retrieve it. Make sure
of the track you are erasing.
1 While playing the track you want to
erase, press ENTER, press
>MENU. repeatedly until
“EDIT” flashes in the display, and
then press ENTER again.
“” and “Name” flash in the
display, and the recorder plays the
selected track repeatedly.
2 Press >MENU. repeatedly
until “” and “Erase” flash in the
display, and then press ENTER.
“Erase?” and “ENTER” appear
alternately in the display.
To cancel erasing, press x.
3 Press ENTER.
The track is erased and the next track
starts to play. All the tracks after the
one erased are automatically
renumbered.
To erase a part of a track
Add track marks at the beginning and the
end of the part you want to erase, then
erase the part (page 26).
To erase the whole disc
You can quickly erase all the tracks and
data of the MD at the same time.
Note that once a recording has been
erased, you cannot retrieve it. Be sure to
check the contents of the disc you want to
erase.
1 While the recorder is stopped, press
ENTER, press >MENU.
repeatedly until “EDIT” flashes in the
display, and then press ENTER again.
“” and “Name” flash in the
display.
x
ENTER
>MENU.
x
ENTER
>MENU.
continued