Filter
Top Products
1-18
MVE-9000 IM
D3704 (H-2) : SYSTEM status LED
Lit when configuration is complete and FPGA reset is also
complete. If the LED does not light, the FPGA may be
defective.
D3705 (H-5) : CN EXIST status LED
CN-2357 board presence/absence status indication.
Lit on the DVP-24A board that is installed in the same slot
of CN-2357 board when CN-2357 board is present.
D3706 (H-6) : CN POWER status LED
The CN-2357 board power status indication.
Lit on the DVP-24A board that is installed in the same slot
of CN-2357 board while the power supply inside the CN-
2357 board is activated.
D3801 (H-1) : DBG 7 A status LED
Used for design purpose.
D3802 (H-1) : DBG 6 A status LED
Used for design purpose.
D3803 (H-1) : DBG 5 A status LED
Used for design purpose.
D3804 (H-1) : DBG 4 A status LED
Used for design purpose.
D3901 (H-6) : DBG 7 B status LED
Used for design purpose.
D3902 (H-6) : DBG 6 B status LED
Used for design purpose.
D3903 (H-7) : DBG 5 B status LED
Used for design purpose.
D3904 (H-7) : DBG 4 B status LED
Used for design purpose.
ND3801 (H-2), ND3802 (H-2) : STATUS A LED
DVP-24A board CPU_A status indication.
ND3901 (H-6), ND3902 (H-6) : STATUS B LED
DVP-24A board CPU_B status indication.
<Switch>
S3501 (H-3) : CPU A CONFIG switch
Used for maintenance purpose.
S3601 (H-3) : CPU B CONFIG switch
Used for maintenance purpose.
S3801 (H-2) : SETUP A switch
Used for maintenance purpose.
S3901 (H-5) : SETUP B switch
Used for maintenance purpose.
<Connector>
CN3502 (H-4) : USB A terminal
Used for maintenance purpose.
CN3503 (H-3) : COM A terminal
Used for maintenance purpose.
CN3602 (H-3) : COM B terminal
Used for maintenance purpose.
CN4301 (H-4) : EPR terminal
Used for maintenance purpose.
CN4601 (H-3) : IEEE1394 terminal
Used for maintenance purpose.
<TEST terminal>
E201 (B-7), E202 (D-7), E301 (C-7), E302 (F-7),
E401 (G-7), E501 (H-5) : GND terminal
Use this terminal as the earth point for measuring the
respective check terminals.
TP201 (B-7) :
++
++
+1.5 V-1/20 A check terminal
+1.5 V-1/20 A measuring terminal.
TP202 (D-7) :
++
++
+1.5 V-2/20 A check terminal
+1.5 V-2/20 A measuring terminal.
TP301 (C-7) :
++
++
+2.5 V-1/20 A check terminal
+2.5 V-1/20 A measuring terminal.
TP302 (F-7) :
++
++
+2.5 V-2/20 A check terminal
+2.5 V-2/20 A measuring terminal.
TP401 (G-7) :
++
++
+3.3 V/20 A check terminal
+3.3 V/20 A measuring terminal.