Filter
Top Products
1-7
MVE-9000 IM
Connecting cable
Harness support
1
2
3
4
5
6
7
8
PSW3 x 6
1
2
3
4
5
6
7
8
Cover panel
B3 x 5
B3 x 5
4. Remove the blank panel from the slots 2 and 4.
5. Attach the cover panel and secure it with the two
screws.
6. Attach the connecting cable on the harness support.
7. Connect the connecting cable to the connector.
8. Secure the harness support to the cover panel using the
two screws supplied with MKE-9020M.
HK-PSU04
PSW3 x 6
PSW3 x 6
1-4-3. Installing the HK-PSU04
The HK-PSU04 is used after it is installed in the MVE-
9000.
c
Before installing the HK-PSU04, be sure to turn off the
main power. If the HK-PSU04 is installed while the main
power is turned on, it can result in electrical shock or
damage to printed circuit boards.
Installation procedure
1. Remove the front panel of the MVE-9000.
(Refer to Section 1-4-1.)
2. Remove the two screws (B3 x 5) fixing the PS cover,
and remove the PS cover.
3. Remove the two screws (PSW3 x 6) fixing the blank
panel, and remove the blank panel.
n
Store the removed blank panel in a safe place.
4. Push the portion of the HK-PSU04 indicated by the
arrow and insert the HK-PSU04 into deep end as far as
it will go.
5. Secure the HK-PSU04 with the two screws removed in
step 3.
6. Install the PS cover and the front panel by reversing
the installation steps of 1, 2.
PSW
3 x 6
B3 x 5
B3 x 5
Blank panel
PS cover