Filter
Top Products
Optional Components
35
US
Listening to audio from a
connected component
Listening to the analog sound
of an MD deck, a VCR, etc.
1 Connect the audio cords.
See “Hooking up optional components” on
page 34.
2 Press 5.1CH/VIDEO (MD)* to select
“VIDEO” or “MD”.
Start playing the connected component.
To switch the VIDEO function to MD
When you listen to a connected MD deck,
perform the following operation.
1 Turn off the system.
2 Press 5.1CH/VIDEO (MD)* while holding
down STOP x.
The function switches to MD.
Tip
Once you enable the MD function, just press 5.1CH/
VIDEO (MD)*.
Notes
• The function is factory-set to VIDEO.
• If you want to switch back to the VIDEO funtion,
perform the operation described above to switch to
the VIDEO function.
• You cannot switch the function in Power Saving
Mode.
* VIDEO (MD) for MHC-GS200 or on the remote.
Recording audio from a
connected component
1 Connect the audio cords.
See “Hooking up optional components” on
page 34.
2 Start recording manually.
See “Recording to a tape” on page 24.
Recording on a connected
component
1 Connect an optical cable.
See “Hooking up optional components” on
page 34.
2 Start recording.
Refer to the operating instructions provided
with connected component.