Filter
Top Products
39
To the audio output of the
MD deck
To the audio output of the video deck
Connecting a VCR
By connecting the audio output jacks of your
VCR to the MD/VIDEO (AUDIO) IN jacks
using an optional audio cable, you can enjoy
video playback in powerful stereo sound.
Make sure to match the color of the plugs and
the connectors. To listen to the sound of the
connected VCR, hold down MD (VIDEO) and
press ?/1 when the power is turned off. This
switches the “MD” function to “VIDEO”.
Once you enable the “VIDEO” function, just
press MD (VIDEO).
Notes
•You cannot switch from MD to VIDEO or from
VIDEO to MD when the system is in the Power
Saving Mode (see page 9).
•To return to “MD”, press ?/1 while pressing MD
(VIDEO) again when the power is turned off.
•When you connect a VIDEO CD deck, set to
“MD”.
Connecting an MD deck
for listening to music
Make sure to match the color of the plugs and
the connectors. To listen to the sound of the
connected MD deck, press MD (VIDEO).
Tip
When you connect a Sony MD deck, you can use the
MD H, S, and s buttons on this unit’s remote to
perform play, pause, and stop operations.
Note
If you cannot select “MD” when you press MD
(VIDEO), press ?/1 while pressing MD (VIDEO)
when the power is turned off. “VIDEO” will be
switched to “MD”. To return to “VIDEO”, do the
same procedure. However, you cannot switch from
MD to VIDEO or from VIDEO to MD when the
system is in the Power Saving Mode (see page 9).