Filter
Top Products
37
GB
Naming a track or MD/Undoing the last edit
Editing Recorded MDs
Use this function to erase the name of a track or disc.
1
While the deck is stopped, playing, recording, or
paused, press MENU/NO.
“Edit Menu” appears in the display.
2
Turn AMS (or press
.
/
>
repeatedly) until
“Name ?” appears, then press AMS or YES.
3
Turn AMS (or press
.
/
>
repeatedly) until “Nm
Erase ?” appears, then press AMS or YES.
4
Turn AMS (or press
.
/
>
repeatedly) until the
number of the track (when erasing the track name)
or “Disc” (when erasing the disc name) flashes,
then press AMS or YES.
“Complete!!” appears for a few seconds and the name
is erased.
To cancel the operation
Press MENU/NO or
x
.
You can erase all the track names and the disc name on an
MD in a single operation.
1
While the deck is stopped, playing, or paused,
press MENU/NO.
“Edit Menu” appears in the display.
2
Turn AMS (or press
.
/
>
repeatedly) until
“Name ?” appears, then press AMS or YES.
3
Turn AMS (or press
.
/
>
repeatedly) until “Nm
AllErs ?” appears, then press AMS or YES.
“Nm AllErs ??” appears in the display.
4
Press AMS or YES.
“Complete!!” appears for a few seconds and all the
names on the MD are erased.
To cancel the operation
Press MENU/NO or
x
.
z
You can erase all the recorded tracks and names on
the MD
For details, see “Erasing all the tracks on an MD” on page 32.
Undoing the last edit
(UNDO)
You can undo the last edit operation and restore the
contents of the MD to the condition that existed before the
operation. Note, however, that you cannot undo an edit
operation if you perform any of the following operations
after the edit:
•
Start recording.
•
Press
z
or MUSIC SYNC on the remote.
•
Change the recorded level after recording (S.F Edit).
•
Turn off the deck or eject the MD.
•
Disconnect the AC power cord.
1
While the deck is stopped and no track number
appears in the display, press MENU/NO.
“Edit Menu” appears in the display.
2
Turn AMS (or press
.
/
>
repeatedly) until
“Undo ?” appears.
“Undo ?” does not appear if no editing has been done.
3
Press AMS or YES.
One of the following messages appears depending on
the last edit operation.
4
Press AMS or YES.
“Complete!!” appears for a few seconds and the MD is
restored to the condition that existed before the edit
operation.
To restore your edit
Press MENU/NO or
x
.
Erasing a track or disc name
Erasing all the names on the MD
Last edit operation Message
Erasing a track
Erase Undo?Erasing all the tracks on an MD
Erasing a portion of a track
Dividing a track Divide Undo?
Combining tracks CombineUndo?
Moving a track Move Undo?
Naming a track or MD
Name Undo?
Copying a track or disc name
Renaming a track or MD
Erasing a track or disc name
Erasing all the names on the MD