Filter
Top Products
Basic Operations
Basic Operations
7
6
Press r.
The recorder stands by for record.
7
When recording the analog input signal, adjust the recording
level with REC LEVEL.
The fourth dot is satisfactory for most purposes. For details,
refer to “Adjusting the Recording Level” on page 11.
8
Press · or P.
Recording starts.
9
Start playing the program source.
Do not turn off the power or disconnect the recorder from the power source
immediately after recording.
If you do, recorded material may not be saved to the MD. To save the
material, after recording, press § EJECT to take out the MD. “TOC” indicator
will flash in the display at this time.
After “TOC” indicator stops flashing and is unlit, you can turn off the power
or pull out the AC power cord.
To
Press
Stop recording
Pause recording* P. Press the button again or press · to
resume recording.
p
Take out the MD
§ EJECT after stopping recording
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
Rear of the disc
Slide the tab in
the direction of arrow
Record-protect tab
When ”TOC“ indicator flashes in
the display
The recorder is currently updating
the Table Of Contents (TOC).
Do not turn off the power, move
the recorder, or pull out the AC
power cord, while “TOC”
indicator is flashing. Changes to an
MD made through recording are
saved only when you update the
TOC by ejecting the MD.