Filter
Top Products
Basic Operations
6
Recording on an MD
Basic Operations
1
Turn on the mixer and program source.
2
Press U.
3
Insert a recordable MD.
With the arrow
pointing this way
With the label side up
If the MD has a recorded material on it, the recorder will
automatically start recording from the end of the last recorded
track.
4
Set INPUT to the corresponding input connector.
5
Select a recording mode from the Set up Menu.
23
768
54
To record through Set INPUT to
ANALOG IN
DIGITAL
ANALOG
DIGITAL IN
COAXIAL
BAL or UNBAL
1 Press EDIT/NO twice to display “Setup Menu.”
2 Wait until “Rec Mode” appears in the display, when press AMS.
3 Turn AMS to the desired recording mode (STEREO or MONO) and press
AMS.
4 Press EDIT/NO..
Monaural recording will last about two times longer than stereo recording.
Analog input
When using the analog input,
switch the rear-panel ANALOG
INPUT (BAL or UNBAL) acording
to the type of the input terminal
used.
Monitor audio during recording
Even if you set REC MODE to
MONO, the monitor signal does
not become monaural.
Recording mode
The last recording mode in effect
will be restored even when you
replace the MD or turn the
recorder off and on.