Filter
Top Products
26
EN
Additional Information
Specifications
Amplifier section
POWER OUTPUT
Stereo mode (4 ohms at 1 kHz THD 0.7%)
100 W + 100 W
Surround mode (4 ohms at 1 kHz THD 0.7%)
Front: 100 W + 100 W
Center
1)
: 100 W
Rear
1)
: 100 W + 100 W
1) Depending on the sound field settings and the
source, sound will not be output.
Frequency response
PHONO: RIAA equalization curve
±0.5 dB
CD, TAPE, DAT/MD, TUNER, VIDEO 1, 2:
10 Hz - 50 kHz
+0
–1
dB (with DIRECT PASS on)
Inputs
Digital signal processor section
Modulation (A/D conversion)
High Density Linear Converter
Demodulation (D/A conversion)
High Density Linear Converter (Advanced pulse
D/A converter)
Sampling frequency
48 kHz
Surround LFE MIX: MUTE, –20 - 0 dB, 0.5 dB step
D. COMP: OFF, 0.1 - 0.9, STD, MAX
REAR level: –20 - +10 dB, 0.5 dB step
CENTER level: –20 - +10 dB, 0.5 dB step
SUB WOOFER level: –20 - +10 dB, 0.5 dB step
EFFECT: 21-step adjustable
WALL: 17-step adjustable
SEAT F/R: 17-step adjustable
SEAT L/R: 17-step adjustable
REVERB time: 17-step adjustable
Depending on the sound field, some parameters
may not be adjustable (see page 21).
Equalizer BAND: BASS/TREBLE
Turnover frequency:
Bass: 99 Hz - 992 Hz
Treble: 1.0 kHz - 8.6 kHz
Level: ±10 dB, 0.5 dB step
Video section
Inputs 1 Vp-p 75 ohms
Outputs 1 Vp-p 75 ohms
General
System Preamplifier section:
Low-noise NF type equalizer
Power amplifier section:
Pure-complementary SEPP
Power requirements
230 V AC, 50/60 Hz
Power consumption
380 W
AC outlets 1 switched, maximum
100 W
Dimensions 430 × 160 × 435 mm including projecting parts and
controls
Mass (Approx.) 15.6 kg
Supplied accessories
See page 4.
Design and specifications are subject to change without
notice.
Impedance
S/N (weighting
network, input
level)
Sensitivity
PHONO
2) ’78 IHF
2.5 mV 50 kilohms
75 dB
2)
(A, 2.5 mV)
82 dB
2)
(A, 150 mV)
50 kilohms150 mV
TAPE, DAT/MD, CD,
TUNER, VIDEO 1, 2, 3,
LD, TV
LD AC-3 RF
LD/TV/CD/DAT MD
OPTICAL
—
—
75 Ω
—
100 dB
(A, 20 kHz LPF)
100 dB
(A, 20 kHz LPF)
LD COAXIAL
0.5 Vp-p 75 Ω
100 dB
(A, 20 kHz LPF)
Outputs VIDEO 1, 2 AUDIO OUT:
Voltage: 150 mV
Impedance: 10 kilohms
PRE OUT:
Voltage: 2 V
Impedance: 1 kilohms
PHONES:
Accepts low and high impedance headphones
BASS BOOST +6 dB at 70 Hz