Filter
Top Products
44
GB
1 Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2 Press TUNING + or TUNING –.
Press TUNING + to scan from low to
high; press TUNING – to scan from high
to low.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and “ST”
flashes on the display, select monaural audio
so that the sound will be less distorted.
To select monaural audio, you can
– press FM MODE repeatedly until the
“MONO” indicator lights up on the display.
– set “FM MODE” in TUNER menu to “FM
MONO” (page 35).
To return to stereo mode, you can
– press FM MODE repeatedly until the
“MONO” indicator on the display do not
light up.
– set “FM MODE” in TUNER menu to “FM
AUTO” (page 35).
You can enter the frequency of a station
directly by using the numeric buttons.
1 Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2 Press D.TUNING.
3 Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
4 Press ENTER.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
Direct tuning
123
46
78
0/10
ENTER
9
SYSTEM STANDBY
VIDEO 1 VIDEO 2 VIDEO 3 DVD
2CH A.F.D. MOVIE MUSIC
MEMORY DVD MENU
FM MODE
CLEAR
AUTO CAL
D.TUNING
D.SKIP
AMP MENU
SAT TV SA-CD/CD TUNER
-
5
>10/
1
2
4
3