Filter
Top Products
18
12345
1 2345
678910
11 12 13 14 15
16 17 18 19 20
ALL
DISCS
1 DISC
12345
1
DISCS
MIN SEC
2345
678910
ALL
Playing the Discs – Continuous Play
This section describes continuous play with the CD section. You can choose to play just
one, or up to five discs.
Before playing a disc, turn on the SYSTEM POWER and set the function selector to the
CD mode.
1 Press
§§
§§
§ to open the disc table.
§
OPEN/CLOSE
2 Place a disc with the label side up.
To play more than one disc, press DISC SKIP to turn
the disc tray and place up to 5 discs.
After placing discs, press § to close the disc table.
Disc tray
/
DISC
SKIP
Disc No.
3 Press CONTINUE to choose whether to play
one disc or all discs.
Each time CONTINUE is pressed, "1 DISC" or "ALL
DISCS" appears alternately.
CONTINUE
4 Press DISC SELECT or · to start playback.
Track numbers on the
selected disc.
When playback of a
track is finished, that
track number goes
out.
To stop play, press p.
To stop play and open the tray, press §.
To stop for a moment during play, press P.
Press · or P to resume playback.
Caution on adjusting volume
Do not turn up the volume while listening to a portion
with a very low level or no audio signals. The speakers
may be damaged when a peak level portion is played.
Notes
• The CD section is automatically turned off in the TUNER
mode. The OPEN/CLOSE and DISC SKIP buttons,
however, can be operated in any mode (including
TUNER). This is useful when recording on tape from CDs.
• The disc number of an empty tray will be displayed until
the empty tray is set to play. Once it is recognized as
empty, it will disappear.
To play an 8 cm (3-inch) CD
If the disc is provided with an adaptor, first remove it, then
place the disc on the inner circle of the tray. Do not put a
normal CD (12 cm/5-inch) on top of an 8 cm CD.
When there are no disc at all on the tray
"no d1SC" appears on the display.
The ( indicator lights up.
Elapsed time in the
track being played
Track number
being played
1
2
3
45
DISC SELECT
or
·
1, 2
4
SYSTEM POWER
n ON
CD
p
P
23