Filter
Top Products
7
3. To end the call, press shortly the on the headset.
Consult your mobile phone’s user guide for alternative ways of switching a call to your headset using the
mobile phone’s key pad.
To switch from using the headset to the mobile phone during a call:
1. Transfer the call by pressing on your headset for 4 seconds until you hear a series of high to low tones.
2. Wait for instructions in the phone’s display and then re-activate the call by pressing the Yes/Call
button on the mobile phone.
3. Continue the call on the handset.
4. To hang up, press the No/End button on the mobile phone.
Note: The headset remains on and is ready for new calls.
Low Battery indications in the headset
When using a mobile:
1. You will hear warning beeps approximately 5 minutes before the battery runs empty.
2. If you have continued your call and the headset switches off, the call can be re-activated on the Yes/Call
button on the mobile phone (follow instruction in the mobile phone’s display).
Using a desk phone:
1. You will hear warning beeps approximately 5 minutes before the battery runs empty.
2. If you have continued your call and the headset switches off, the base will hold the call for 20 seconds
and then transfer it to the telephone’s handset.
If you are close to the base, you may press its Multifunction button and transfer the call to the handset
immediately.
4. Audio and visual indicators
The GN 6210’s headset and base have audio and visual indicators, which represent various actions and
aspects associated with setting up and operating the product. Familiarise yourself with these indicators to
fully benefit from your GN 6210.
The headset’s audio indicators:
Headset action Audio indication
Volume Limit Repeated single high tone when min. or max. limits achieved (when button
is pressed)
Low Battery Tone Two rapid high tones repeated every 20 seconds
Out of Range No audio indications; gradual deterioration of audio quality
Incoming Call from Mobile Ring tone A
Incoming Call from desk phone Ring tone B (only when using hook switch)
Pairing Confirmation
– with base 2 single tones
– with mobile 1 single tone
Establish Audio Link Series of tones, low to high
Initiate Voice Dial Double tone
Voice Tag not Recognised Dual high-low tone
End Call/Audio Link Closed Series of tones, high to low
Power ON/OFF Low to high/high to low tone
GN6210_UG_4.10 04/10/04 14:55 Side 7