Filter
Top Products
3
2. Use with desktop telephone
2.1 Tips for connecting cords
For your convenience, you may feed the telephone handset cord through the base’s right or left Cord Slot,
depending on the positioning of your telephone.
Use the Cord Management Strips to fasten and organise the cords.
Note: If you connect the Telephone Connection Cord to your telephone’s headset socket instead of the
handset socket, this will enable the telephone’s line button. You can now answer and end calls by pressing
the line button instead of using the handset. The handset can remain connected to the telephone.
2.2 Pairing headset with base
The headset and the base in their original product box have been factory-paired to ensure instant function-
ing of your GN 6210. You do not need to pair these two devices, and you may now proceed to the Clear
dial tone adjustment section.
If original pairing is lost (by resetting the base, changing your headset or changing your base), you will have
to pair your headset to the base again:
1. Ensure your headset is turned off.
1. Turning headset on and off
What you do What you hear What you see
Turning headset
ON
Press and hold for 3 seconds until
you see a burst of flashes on the blue
indicator light, then release
Ascending (low-to-high)
tones
The blue indicator light will
flash while the power is on
(see Status indicators page 8)
Turning headset
OFF
Press and hold for 4 seconds until
you see a burst of flashes on the blue
indicator light, then release
Descending (high-to-low)
tones
The blue indicator
light will stop flashing
GN6210_UG_4.10 04/10/04 14:55 Side 3