Filter
Top Products
66
Settings and Adjustments
To obtain the best possible surround sound when you use
the 5.1 CH OUTPUT connectors, use the SPEAKER
SETUP display to first specify the size of the speakers you
have connected and their distance from your listening
position. Then set the balance and level. Use the test tone
to adjust the volume of the speakers to the same level.
For speaker hookup instructions, see page 14.
The default settings are underlined.
Select “SPEAKER SETUP” in the setup display.
x SIZE
Selects the size of the speakers to be connected.
• FRONT
—
LARGE: Normally select this.
— SMALL: When the sound cracks or the surround
sound effects are difficult to hear, select this. This
activates the Dolby Digital bass redirection circuitry
and outputs the bass frequencies of the speaker from
the subwoofer.
• CENTER
—
NONE: If you do not connect a center speaker, select
this.
— LARGE: Normally select this.
— SMALL: When the sound cracks, select this. This
activates the Dolby Digital bass redirection circuitry
and outputs the bass frequencies of the center
speaker from other speakers .
• REAR
—
NONE: If you do not connect rear speakers, select
this.
— LARGE (REAR/SIDE): Normally select either of
these according to the rear speaker’s position*.
— SMALL (REAR/SIDE): When the sound cracks or the
surround sound effects are difficult to hear, select
either of these according to the rear speaker’s
position*. This activates the Dolby Digital bass
redirection circuitry and outputs the bass frequencies
of the rear speaker from other speakers .
Settings for the Speakers
(SPEAKER SETUP)
SPEAKER SETUP
SIZE:
DISTANCE:
BALANCE:
LEVEL:
OFF
TEST TONE:
FRONT:
CENTER:
YES
LARGE
(
REAR
)
LARGE
LARGE
REAR:
SUBWOOFER:
To set, press , then .
To quit, press .
ENTER
SETUP
.
DISPLAY
Settings for the Sound (AUDIO SETUP)
x 48kHz/96kHz PCM (DVD only)
Selects the sampling frequency of the audio signal to be
output via the DIGITAL OUT OPTICAL and COAXIAL
connectors.
•
48kHz/16bit: The audio signals of DVDs are always
converted to 48 kHz/16 bit.
• 96kHz/24bit: All types of signals including 96 kHz/24
bit are output in their original format. However, if the
signal is encrypted for copyright protection purposes,
the signal is only output as 48 kHz/16 bit.
Notes
• If you select “96kHz/24bit” when a receiver (amplifier) which
cannot accept 96 kHz is connected to the player, no sound or a
loud noise will come out from the speakers.
• Even if you set “48kHz/96kHz PCM” in “AUDIO SETUP” to
“96kHz/24bit,” the sampling frequency is converted to 48
kHz/16 bit when a VIRTUAL 3D SURROUND mode is
selected.
• The analog audio signals from the AUDIO OUT connectors are
not affected by this setting and keep their original sampling
frequency level.