Filter
Top Products
10
GB
D:\NORM'S JOB\SONY HA\SO0190\STR-DH730_DH830_PMRF
01\4408151112_GB\GB03DES_STR-DH730-CEL.fm
masterpage: Left
STR-DH830/STR-DH730
4-408-151-11(2)
Indicators on the display panel
LH
LFE
NEO
:
6
DTS
-
HD
MSTR
HI RES
LBR
PL II
xz
HDMI
-
ESDTS
TrueHD
96/24
SLEEP
D.RANGEST
RDS
COAX OPT
LPCM
RH SW
L C
S
R
SL SR
SBL SBR
D
+
EX
SB
q
s
q
d
q
a
1 23 4 5 897
0
6
A Playback channel indicators
The letters (L, C, R, etc.) indicate the channels
being played back. Based on the speaker
settings, the box around the letter(s) vary to
show how the receiver downmixes the source
sound.
LH
RH
L
R
C
SL
SR
S
SBL
SBR
SB
Front Left High
Front Right High
Front Left
Front Right
Center (monaural)
Surround Left
Surround Right
Surround (monaural or the
surround equipment
obtained by Pro Logic
processing)
Surround Back Left
Surround Back Right
Surround Back (the
surround back equipment
obtained by 6.1 channel
decoding)
Example:
Speaker pattern: 3/0.1
Recording format: 3/2.1
Sound Field: A.F.D. AUTO
B SW
Lights up when the audio signal is output from
the SUBWOOFER jack.
C
Lights up when the disc being played back
contains an LFE (Low Frequency Effect)
channel and the LFE channel signal is actually
being reproduced.
LFE
SW
L C R
SL SR
LFE
D Input indicator
Lights up to indicate the current input.
HDMI
– The INPUT MODE is set to “AUTO”, and
when the receiver recognizes the equipment
connected via an HDMI IN jack (page 23, 59).
– TV input detected Audio Return Channel
(ARC) signals.
COAX
The INPUT MODE is set to “AUTO” or
“COAX”, and when the source signal is a digital
signal through the COAXIAL jack (page 25, 59).
OPT
The INPUT MODE is set to “AUTO” or “OPT”,
and when the source signal is a digital signal
through the OPTICAL jack (page 22, 25, 26, 59).
E DTS(-ES) indicator
Lights up the respective indicator when the
receiver is decoding the corresponding DTS
format signals.
DTS
DTS-ES
DTS 96/24
DTS
DTS-ES
DTS 96 kHz/24 bit
Note
When playing a DTS format disc, make sure that
you have completed the digital connections and
that INPUT MODE is not set to “ANALOG”
(page 59) or “A. DIRECT” is not selected.
F NEO:6
Lights up when DTS Neo:6 Cinema/Music
decoder is activated (page 52, 53).