Filter
Top Products
30
GB
Specifying the speaker parameters
To obtain the best possible surround sound, set the size of the speakers you have connected and
their distance from your listening position. Then use the test tone to adjust the level and the
balance of the speakers to the same level.
Select “SPEAKER SETUP” in the setup display. For details, see “Using the Setup Display” (page
69).
The default settings are underlined.
To return to the default setting
Select the item, then press CLEAR.
xSIZE
If you do not connect center or rear speakers, or move the rear speakers, set the parameters for
CENTER and REAR. Since the front speaker and subwoofer settings are fixed, you cannot
change them.
FRONT
CENTER
REAR
SUBWOOFER
Notes
• When you select an item, the sound cuts off for a moment.
•Depending on the settings of other speakers, the subwoofer may output excessive sound.
SPEAKER SETUP
DISTANCE:
SIZE:
BALANCE:
LEVEL:
CONNECT:
TEST TONE:
Note on placing speakers
Use caution when placing the subwoofer or front/rear speakers on a specially treated (waxed,
oiled, polished, etc.) floor, as staining or discoloration may result.
YES
YES: Normally select this.
NONE: Select this if no center speaker is used.
BEHIND, SIDE: Specify the position and height to implement the Digital
Cinema Surround modes.
NONE: Select this if no rear speaker is used.
YES