Filter
Top Products
9
GB
Getting Started
2: Configuring the
network settings of the
receiver
The network settings for the receiver must be
set correctly to use the network functions of
the receiver.
You can make the required network settings
for the receiver by following the instructions
provided by an initial setup wizard.
The procedure used to set up the IP address
automatically (DHCP) is explained below.
In this case, the router that is connected to the
receiver or the Internet provider must support
DHCP.
1 Press AMP.
The receiver can be operated using the
remote.
2 Press MENU.
The menu is displayed on the TV screen.
3 Press V/v repeatedly to select
“ Settings,” then press or
b.
4 Press V/v repeatedly to select
“Network,” then press or b.
5 Press V/v repeatedly to select
“Network Setup,” then press
.
“Start Network function Setup Wizard”
appears on the TV screen.
6 Press to select “Next.”
7 Press to select “Connect
Automatically (DHCP).”
“Success! Your device is now connected
to your network.” appears on the TV
screen when you have succeeded in
making a connection.
If the failure screen is displayed, perform
the process referring to “Changing the
network settings” (page 27), after you
have completed this process.
8 Press to select “Finish.”
9 Press to select “ON.”
The setting of the server function is
turned to ON.
Select “OFF,” when you will not use the
server function.
10Press to select “Finish.”
To set the network settings
manually
Refer to “Configuring network settings
manually” (page 27).
Note
The wizard screen appears on the TV screen each
time you use the network function, until the network
function setup has been completed.
AMP
V/v/b,
MENU