Filter
Top Products
CD/MP3 – Play
11
GB
You can make a program of up to 25 steps.
You can synchro record the programed tracks
onto a cassette tape (page 16).
MP3 audio tracks cannot be played on CMT-
NE3.
1 Press CD to switch the function to CD.
2 Press PLAY MODE in stop mode
repeatedly until “PGM” appears.
3 Press ./> repeatedly until the
desired track number appears.
For CMT-NE5 only:
When programing an MP3, press ALBUM
+/– repeatedly to select the album, then
press ./> repeatedly until the
desired track number appears.
4 Press ENTER on the remote.
The track is programed.
The program step number appears,
followed by the last programed track
number and total playing time.
5 To program additional tracks, repeat
steps 3 and 4.
6 Press N.
Program Play starts.
Other operations
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press N
(or CD/NX on the unit). However, the program is
cleared when you open the CD compartment.
• “– –.– –” appears if the total program time exceeds
100 minutes, if you select a track whose number is 21
or over, or when you programed an MP3 audio track.
Creating your own
program
— Program Play
Selected track number Total playing time
(including selected
track)
To Do this
Cancel Program
Play
Press PLAY MODE in stop
mode repeatedly until both
“PGM” and “SHUF(FLE)”
disappears.
Erase the program Press CLEAR in stop mode.
Each time you press the button, a
track is cleared from the end of
the program.
Add a track to the
end of the program
Perform steps 3 and 4 in stop
mode.