Filter
Top Products
CMT-BX50BTi.GB.3-293-642-11(1)
19
GB
Basic Operations
Pairing this system with Bluetooth
headphones
Pairing is an operation where Bluetooth
devices register with each other
beforehand. Use the procedure below
to pair the system with your Bluetooth
headphones. Once a pairing operation
is performed, it does not need to be
performed again. If pairing is already
completed, proceed to “Playing music on
this system” (page 20).
1
Select a function other than the
Bluetooth function.
Press FUNCTION +/ (or
FUNCTION on the unit)
repeatedly.
2
Place the Bluetooth
headphones to be connected
to this system within 1 meter of
the system.
3
Put the Bluetooth headphones
in pairing mode.
For details about the operations of the
Bluetooth headphones, refer to the
operation manual supplied with your
Bluetooth headphones.
4
Press and hold BLUETOOTH
on the unit for about 7 seconds
until the BLUETOOTH indicator
ashes.
Sound output from the speakers is
stopped.
5
Enter the passkey.
Follow the same procedure as in
step 4 of “Pairing this system with a
Bluetooth device” (page 16).
Once pairing is completed and the
connection is established, the system
display changes as follows:
“Connect”
Name of the Bluetooth
device
To cancel passkey entry partway
Press
.
Notes
“Passkey” may be called “Passcode,” “PIN
code,” “PIN number” or “Password,” etc.
depending on the device.
is system only supports numerical
passkeys up to 4 digits.
e pairing standby status of the system is
cancelled aer about 30 seconds.
If pairing is not successful, redo the
procedure from step 1.
While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.
Pairing may not be possible if other
Bluetooth devices are present around the
system. In this case, turn o the other
Bluetooth devices.
To erase all the pairing registration
information
1
Press BLUETOOTH
on the
unit.
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH
on the
unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
.
“Delete?” appears.
3
Press
.
“Complete!” appears and all the
pairing information is erased.
Note
To connect with Bluetooth headphones aer
performing this operation, you must enter the
passkey again.
Continued