Filter
Top Products
CMT-BX50BTi.GB.3-293-642-11(1)
17
GB
Basic Operations
To erase all the pairing registration
information
1
Press BLUETOOTH
on the
unit.
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH
on the
unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
.
“Delete?” appears.
3
Press
.
“Complete!” appears and all the
pairing information is erased.
Note
In order to connect with a Bluetooth device
aer performing this operation, you must enter
the passkey again.
Playing music of a Bluetooth device
You can operate a Bluetooth device by
connecting the system and a Bluetooth
device using AVRCP.
1
Select the Bluetooth function.
Press BLUETOOTH
on
the unit.
2
Establish a connection from the
Bluetooth device.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
Once the connection is established,
the system display changes as follows:
“Connect”
Name of the Bluetooth
device
3
Start playback.
Press (or BLUETOOTH on
the unit)
.
Depending on the Bluetooth device,
you may need to start up the AV
soware of the Bluetooth device
beforehand.
4
Adjust the volume.
Press VOLUME +/ (or VOL +/ on
the unit)
.
To check the address of a connected
Bluetooth device
Press DISPLAY
while the Bluetooth
device name appears in the system
display.
e Bluetooth device address appears for
8 seconds.
To cancel the connection with a
Bluetooth device
Press and hold BLUETOOTH
on the unit for about 2 seconds until
“Disconnect” appears, or until the
information on the display (device name,
etc.) disappears.
Other operations
To Press
Pause playback (or BLUETOOTH
on the unit)
.
Stop playback
.
Select a folder
+/
.
Select a le /
.
Find a point in
a le
Hold down /
.
Note
ese operations may not be available for
certain Bluetooth devices. In addition, the
actual operations may dier depending on the
connected Bluetooth device.
Continued