Filter
Top Products
Tuner
13
GB
To change the AM tuning interval
(Except for European model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune into any AM station
first, then turn off the power by pressing ?/1.
While holding TUNING +, press ?/1.
When you change the interval, all AM preset
stations are erased. To reset the interval, repeat
the above procedure.
To improve tuner reception
When tuner reception is poor, set CD player
power off by the CD power manage function.
CD power is factory set to on.
1 Press FUNCTION repeatedly to switch the
function to CD.
2 Press ?/1 to turn off the system.
3 Press ?/1 on the unit while holding x (CD
stop) on the unit.
“CD POWER” and “OFF” appear.
To set the CD power on
Repeat the procedure above, and “CD POWER”
and “ON” appear.
Notes
• When “CD POWER” and “OFF” are selected, CD
access time is increased.
• In the Power Saving Mode, switching the CD power
on or off using the CD power manage function is not
possible.
Tips
• The preset stations are retained for about half a day
even if you disconnect the power cord or if a power
failure occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 12).
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“PRESET” appears in the display.
3 Press +/– (or TUNING +/– on the unit)
repeatedly to select the desired preset
station.
Listening to non-preset radio
station
— Manual Tuning
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
3 Press +/– (or TUNING +/– on the unit)
repeatedly to tune in the desired
station.
Listening to the radio
continued