Filter
Top Products
CD/MP3 – Play
11
GB
You can make a program of up to 25 steps.
You can synchro record the programed tracks
onto a cassette tape (page 16).
MP3 audio tracks cannot be played on CMT-
GPX5.
1 Press CD (or FUNCTION repeatedly on
the unit) to switch the function to CD.
2 Press PLAY MODE in stop mode
repeatedly until “PGM” appears.
3 Press ./> (or .m/M>
on the unit except for CMT-GPX5)
repeatedly until the desired track
number appears.
When programing an MP3, press ALBUM
+/– repeatedly to select the album, then
press ./> (or .m /M> on
the unit except for CMT-GPX5) repeatedly
until the desired track number appears.
4 Press ENTER.
The track is programed.
The program step number appears,
followed by the last programed track
number.
5 To program additional tracks, repeat
steps 3 and 4.
6 Press N (or CD/NX on the unit).
Program Play starts.
Other operations
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press N
(or CD/NX on the unit). However, the program is
cleared when you eject the disc.
• “– –.– –” appears if the total program time exceeds
100 minutes, if you select a track whose number is 21
or over, or when you programed an MP3 audio track.
• If you select “AL” in step 3, you can select all tracks
on the disc at once. If you select an album in step 3,
you can select all MP3 audio tracks in the album at
once.
Creating your own
program
— Program Play
Selected track number Total playing time
To Do this
Cancel Program
Play
Press PLAY MODE in stop
mode repeatedly until both
“PGM” and “SHUF” disappears.
Erase the program Press CLEAR in step 4.
Each time you press the button, a
track is cleared from the end of
the program.
Add a track to the
end of the program
Perform steps 3 and 4 in stop
mode.