Filter
Top Products
24
(With the card remote commander)
Adjusting the volume level
You can adjust the volume for each connected
audio equipment.
1 Press (MENU).
2 Press (DISC/PRESET) (+) or
(DISC/PRESET) (–) repeatedly to select
“AUX LVL.”
3 Press (ENTER).
4 Press (DISC/PRESET) (+) or
(DISC/PRESET) (–) repeatedly to select
a desired volume level.
The volume level is adjustable in 1 dB steps
from –6 dB to +6 dB.
5 Press (ENTER).
(With the card remote commander)
To deactivate auxiliary equipment in
the source display
1 Press (OFF).
CD/MD playback or radio reception stops.
2 Press (MENU).
3 Press (DISC/PRESET) (+) or
(DISC/PRESET) (–) repeatedly until
“AUX-A-ON” appears.
4 Press (SEEK) (+) to select “AUX-A-
OFF.”
5 Press (MENU).
To restore the indication, select “AUX-A-ON.”
Additional Information
Maintenance
Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse blows
again after replacement, there may be an internal
malfunction. In such a case, consult your nearest
Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front panel
are not clean. In order to prevent this, detach the
front panel (page 9) and clean the connectors
with a cotton swab dipped in alcohol. Do not
apply too much force. Otherwise, the connectors
may be damaged.
Notes
• For safety, turn off the ignition before cleaning the
connectors, and remove the key from the ignition
switch.
• Never touch the connectors directly with your fingers
or with any metal device.
Fuse (10 A)
Main unit
Back of the front panel