Filter
Top Products
11
Installing the Drive in Your Computer
This section provides the basic instructions you need to install the
drive and host adapter in your computer. You should also read the
manual of your computer for specifics of how to install internal
devices.
Preparation
You need the following parts and tools (these are not supplied with
the drive):
• A flat-blade screwdriver
• Four screws 3 mm in diameter (these should not protrude over 6.0
mm from the surface of the side panels or the bottom plate.)
• Two mounting rails if your computer has mounting tracks.
Unplug the computer and disconnect the cables attached to the back
to give yourself more room to work. Do not turn on the power of the
computer before completing the entire installation process.
Setting the Jumpers
Set the jumpers on the rear of the drive in accordance with the
configuration of your computer system.
PARITY
ID SELECT
1 2 3
PREVENT / ALLOW
TEST MODE
TERM
Installing the Drive in Your Computer