Sony BDV-F500 Home Theater System User Manual


 
15
GB
Getting Started
Note
Place the speakers on a flat and firm floor (not on thick pile carpet, for example).
• Leave a space for inserting/ejecting the disc (approximately 15 cm) to the right (disc slot) side of the unit when
placing an object nearby.
• Use caution when placing the speakers and/or speaker stands attached to the speakers on a specially treated (waxed,
oiled, polished, etc.) floor, as staining or discoloration may result.
Do not lean or hang on a speaker, as it may fall down.
Image distortion on the TV screen may occur depending on the location of the subwoofer. In this case, place the
subwoofer away from the TV.
Do not block the ventilation slots of the unit (page 8).
Place both front speakers the same distance apart from the listening position.
The front speakers should be placed at least 0.6 m apart.
Place the front speakers forward from the TV. Make sure there are no reflecting obstacles in front of the speakers.
Both front speakers should be pointed straight forward. Do not place the speakers at an angle.
To set the speakers at a vertical angle
(BDV-F500 only)
You can select the angle for the front speaker: vertical or upward. (The speakers are set to an upward
angle at the factory.)
1 Remove the screws (pre-installed) at the bottom of the speaker.
These screws are used when reassembling the speaker. Be sure not to lose the screws.
2 Detach the speaker stand.
Approximately 15 cm
Screws