Filter
Top Products
External Audio Device
41
US
When using S-AIR products, neighbors may
also receive your system’s sound if IDs are the
same, or you may receive sound from neighbors.
To prevent this, you can identify the unit with a
specific S-AIR sub unit by performing the
pairing operation.
When you perform pairing, wireless
transmission is activated between the paired
main unit and S-AIR sub unit only.
1 Place the S-AIR sub unit that you want
to pair near the unit.
2 Match the IDs of the unit and the S-AIR
sub unit.
• To set the ID of the unit, see “To set the ID
of the unit” (page 39).
• To set the ID of the surround amplifier,
see “To set the ID of the surround
amplifier” (page 39).
• To set the ID of the S-AIR receiver, refer
to the operating instructions of the S-AIR
receiver.
3 Press HOME.
The home menu appears on the TV screen.
4 Press C/c to select [Setup].
5 Press X/x to select [System Settings],
then press .
6 Press X/x to select [S-AIR Settings],
then press .
The [S-AIR Settings] display appears.
7 Press X/x to select [Pairing], then
press .
8 Start pairing of the S-AIR sub unit.
xFor the surround amplifier
Press "/1 on the surround amplifier to turn
on the surround amplifier and press
PAIRING on the rear panel of the surround
amplifier. (To press PAIRING, a slim
instrument, such as a paper clip, can be
used.)
xFor the S-AIR receiver
Refer to the operating instructions of the
S-AIR receiver.
9 Press C/c to select [Start], then press
.
The unit starts pairing.
The PAIRING indicator of the surround
amplifier flashes when pairing starts.
When wireless transmission is activated,
the PAIRING indicator of the surround
amplifier turns on.
To cancel pairing, select [Cancel].
Note
• Perform pairing within several minutes of Step
9. If you do not, [Pairing failed. Retry?] appears
on the TV screen. To continue pairing, select
[OK] and press , then start again from Step 8.
To cancel pairing, select [Cancel].
To cancel pairing
Change the ID of the main and sub unit
(page 39).
You can check the S-AIR status such as the
S-AIR ID or pairing information.
1 Press HOME.
The home menu appears on the TV screen.
2 Press C/c to select [Setup].
3 Press X/x to select [System Settings],
then press .
4 Press X/x to select [S-AIR Settings],
then press .
The [S-AIR Settings] display appears.
The S-AIR ID of the unit appears on the
[Info] line. When the unit is paired,
[Pairing] appears after the ID.
5 Press RETURN.
The system returns to the previous display.
Identifying the unit with a
specific S-AIR sub unit
(Pairing operation)
For the surround amplifier
For the S-AIR receiver
Checking the S-AIR status of
the unit