Filter
Top Products
36
US
2 Press C/c to select [Setup].
3 Press X/x to select [Audio Settings],
then press .
4 Press X/x to select [Auto Calibration],
then press .
The confirmation display for [Auto
Calibration] appears.
5 Connect the calibration mic to the
A.CAL MIC jack on the rear panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied). The front of
each speaker should face the calibration
mic, and there should be no obstruction
between the speakers and the calibration
mic.
6 Press X/x to select [OK].
To cancel, select [Cancel].
7 Press .
[Auto Calibration] starts.
The system adjusts the speaker settings
automatically.
Be quiet during the measurement.
• Before [Auto Calibration], make sure that the
surround amplifier is turned on and you install
the surround amplifier in an appropriate location
to ensure wireless connection with it.
8 Confirm the result of [Auto
Calibration].
The distance and level for each speaker
appear on the TV screen.
• If measurement fails, follow the message then
retry [Auto Calibration].
9 Press X/x to select [OK] or [Cancel],
then press .
xThe measurement is OK.
Disconnect the calibration mic, then select
[OK]. The result is implemented.
xThe measurement is not OK.
Follow the message, then select [OK] to
retry.
• While [Auto Calibration] is in progress, do not
operate the system.
• You can change the unit of measurement (feet or
meters) by pressing the color button (RED).
Setting the Speakers
[Speaker Settings]
To obtain the best possible surround sound, set
the speakers’ distance from your listening
position. Then use the test tone to adjust the
balance of the speakers.
1 Press HOME.
The home menu appears on the TV screen.
2 Press C/c to select [Setup].
3 Press X/x to select [Audio Settings],
then press .
4 Press X/x to select [Speaker Settings],
then press .
The [Speaker Settings] display appears.
5 Press X/x to select the item, then press
.
Check the following settings.
x[Distance]
When you move the speakers, be sure to set the
parameters of the distance from the listening
position to the speakers.
You can set the parameters from 0 to 23 feet (0.0
to 7.0 meters).
[Front Left/Right] 10 ft/3.0 m
: Set the front
speaker distance.
[Center] 10 ft/3.0 m: Set the center speaker
distance.
[Surround Left/Right] 10 ft/3.0 m: Set the
surround speaker distance.
[Subwoofer] 10 ft/3.0 m: Set the subwoofer
distance.
• You can change the unit of measurement (feet or
meters) by pressing the color button (RED).
x[Level]
You can adjust the sound level of the speakers.
You can set the parameters from –6.0 dB to +6.0