Filter
Top Products
36
GB
•Code 31
1
Press .
2 Perform the Auto Calibration again.
•Code 32, 33
1
When you press , “RETRY? YES” appears.
2 Press V/v to select “RETRY? YES”, then press
.
3 Perform the Auto Calibration again.
When you select “WARN
CHECK”
If a warning on the measurement result is
present, detailed information is displayed.
Press to return to step 1 of
“Confirming/saving the
measurement results” (page 33).
You can use the AUTO CAL menu to make
various adjustments for Auto Calibration
settings and to name inputs.
Select “AUTO CAL” in the amplifier menus.
For details on adjusting the parameters, see
“Navigating through menus” (page 42) and
“Overview of the menus” (page 43).
x A.CAL START (Auto Calibration)
x CAL TYPE (Calibration type)*
• FULL FLAT
Makes the measurement of frequency from
each speaker flat.
• ENGINEER
Sets the frequency characteristics to a set
that matches that of the Sony listening room
standard.
• FRONT REF
Adjusts the characteristics of all speakers to
match the characteristics of the front
speaker.
•OFF
Sets the Auto Calibration equalizer level to
off.
* You can select this parameter only when you have
performed the Auto Calibration and saved the
settings.
xPOSITION (Position)
You can register 3 patterns as position 1, 2 and
3 (POS. 1, POS. 2 and POS. 3), depending on
the seating position, listening environment and
measurement conditions. You can also load
the registered setting.
xNAME IN (Naming inputs)
You can rename the position name. For
details, see “Naming inputs” (page 80).
AUTO CAL menu parameters