Filter
Top Products
14
GB
5 Press TUNING +/– (or press –. or
>+ on the remote) repeatedly to
select the preset number you want.
6 Press ENTER.
“Complete!” appears in the display. The
station is stored.
7 Repeat steps 1 to 6 to store other
stations.
Manual tuning preset
You can manually tune in and store the
frequency of your favourite stations.
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE on the remote
repeatedly until “MANUAL” lights up in
the display.
3 Press TUNING +/– (or press –. or
>+ on the remote) repeatedly to tune
in the station you want.
4 Press TUNER MEMORY on the remote.
A preset number flashes in the display.
The stations are stored from preset
number 1.
5 Press TUNING +/– (or press –. or
>+ on the remote) repeatedly to
select the preset number you want.
6 Press ENTER.
“Complete!” appears in the display. The
station is stored.
7 Repeat steps 1 to 6 to store other
stations.
Other operations
To improve tuner reception
When tuner reception is poor, set the CD power
manage function to “CD POWER OFF”. The
default setting is “CD POWER ON”.
Use buttons on the unit for the operation.
1 Press CD.
2 Press ?/1 to turn off the system.
3 Press ?/1 while holding x.
The system turns on automatically. “CD
POWER OFF” appears in the display.
To set to “CD POWER ON”
Repeat the procedure above and “CD POWER
ON” appears in the display.
Notes
• When “CD POWER OFF” is selected, disc access
time is increased.
• You cannot change the CD power manage function
setting in the Power Saving Mode (page 24).
To change the AM tuning interval
Use buttons on the unit for the operation.
The factory settings for AM tuning interval is
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, select any AM station first,
then turn off the system. While holding down
ENTER, press ?/1. The system turns on
automatically and “AM 10k STEP” or
“AM 9k STEP” appears in the display. When
you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode (page 24).
Tips
• The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
• If you press TUNER/BAND while the system is
turned off, the system turns on automatically and
“TUNER” is selected as the function.
• You can also press FUNCTION on the remote
repeatedly to select “TUNER”.
To Do this
Tune in a station
with a weak signal
Follow the procedure described
in “Manual tuning preset” on
page 14.
Stop scanning
during automatic
tuning
Press x.
Cancel presetting Press TUNER MEMORY on
the remote.