Filter
Top Products
12
5. MIX IN: Connect your computer’s (or other device) audio output to this stereo input
to hear audio mixed in with Sirius radio, FM, AM, or an auxiliary device if connected.
The Mix volume for the mixed source must be adjusted at the connected device.
This jack accepts a 1/8" stereo male mini plug.
6. AUX IN: To hear audio from another device, such as a CD player, TV, or computer,
connect said device’s audio output to this stereo input and switch the front source
knob to Aux. Switching to the Aux position does not turn on the connected device.
This stereo input accepts a 1/8" stereo male mini connector. Note you may need to
adjust the volume level differently for an auxiliary device than the level used for
radio listening.
7. SIRIUS EXTERNAL ANTENNA: Plug the Sirius antenna’s female connector into this
male input. Place the antenna on a window sill or outside the house and adjust
the tilt. Position the antenna according to the directions in the section marked
“Reception”. In some metropolitan areas there may be adequate terrestrial signal
available, eliminating the need for window sill or outdoor placement.
8. BALANCE CONTROL: If Tivoli Audio’s Stereo Speaker (sold separately) is not
connected, leave this control turned all the way to the Left and leave the Mono/Stereo
switch in the Mono position. If the Stereo Speaker is connected, set the Mono/Stereo
switch to Stereo. Turn the Balance Control clockwise to hear the Left (main unit)
speaker, or counterclockwise to hear the Right (Stereo) speaker. The center detent
provides equal balance between the two speakers. The balance control does not
affect the headphone output.
9. R-SPR OUT: Connect the Tivoli Audio Stereo Speaker’s (sold separately) male
RCA to this female RCA output, switch the Mono/Stereo switch to Stereo, and
position the balance control to the center detent. Connecting a speaker other
than Tivoli Audio’s Companion Speaker could damage the Model Satellite and
will void your warranty.
10. MONO/STEREO SWITCH: This switch should remain in the Mono position unless
Tivoli Audio’s Stereo Speaker (sold separately) is connected, in which case the
Stereo position should be selected. Note the Mono position may help to clean-up
static noise on some analog FM stations. The headphone’s stereo output is unaffected
by this switch unless you are listening to FM with the switch in the Mono position
(or listening to AM which is mono).
11. SUB OUT: Connect Tivoli Audio’s Model Subwoofer (sold separately) to this output
to enhance the bass. This jack accepts a 1/8" stereo male mini plug.
12. EXTERNAL AM ANTENNA: Connect the included external AM loop antenna’s
1/8” stereo male mini plug to this input. Fold the plastic base together and
position for best AM reception for each AM station. For more, see the section
marked “Reception”.