Filter
Top Products
- 10 -
Notice:
Only the built-in batteries can be charged, not the batteries that
may have been placed in the battery compartment.
Switching the device on and o
To switch the device on, turn the > O/volume regulator a
clockwise over a small resistance.
To switch the radio o, turn the
> O/volume regulator a
anti-clockwise, and over the small resistance, until it comes
to a stop.
Receiving radio transmissions
Using the > frequency range switch FM/AM o, select the
required waveband:
FM = Very High Frequency (VHF), >
AM = Medium Wave (MW). >
For VHF reception, extend the telescope aerial
> y to its full
length and then determine its best positioning.
The device has a built-in aerial for the reception of MW
>
transmitters. To improve reception, if needed, turn the radio
until it is in the most favourable position.
Turn the transmitter calibration TUNING
> i, to receive the
desired radio station. Use the tuning scale s for orientation.
In the case of VHF transmitters, reception strength is shown
>
by the TUNE indicator
e. The brighter it glows, the better
the reception.
Select the desired sound volume with the
> OFF/VOLUME
regulator a.