Filter
Top Products
- 9 -
Then insert the plug of the power adapter into a mains >
power socket whose voltage matches the information given
on the power adapter type plate.
Switching between power supplies
The DYNAMO/BATTERY switch d, with which you can select
dierent power sources, is located on the rear of the device.
Place this switch in the position DYNAMO to power the
>
device from the built-in Ni-MH batteries.
Place this switch in the position BATTERY to power the
>
device from the batteries in the battery compartment.
Power provision from a mains power adapter functions in
>
both switch positions.
Charging the batteries
Should the device functions diminish whilst it is being powerered
from the built-in Ni-MH batteries, it means they are drained.
In this case, fold out the lever of the dynamo crank
> f and
then turn the dynamo any direction until the functions are
restored.
During the period that the batteries are being charged, the
>
CHARGE indicator r lights up.
When done, place the dynamo crank
> fback into its rest
position.