Filter
Top Products
10ENGLISH
CONNECTING RECEIVERS
Single UA845 Setup
1.
Using low-loss, 50
Ω coaxial cables (RG-58 or equivalent), con-
nect the right and left (Channels 1 through 4, A and B) RF
OUTPUT ports on the UA845 to the corresponding left and
right antenna inputs on each receiver. Use the CASCADE ports
to connect a fifth receiver.
2. Using the supplied power cable, connect the UA845 to a power
outlet.
3. To daisy-chain U4 Receivers together with Power OUTPUT
cables, connect the Power OUTPUT connector of the UA845 to
the Power INPUT connector of one receiver. Connect the
remaining receivers similarly. Connect the POWER INPUT of
the unit to a power supply.
NOTE: No more than five (5) Shure UHF receivers should be
powered through a daisy-chain from a single UA845.
4. To power Shure UC4 receivers, connect the power input ports of
the UC4 receivers to the 12 Vdc OUT of the UA845. Up to four
UC4 Receivers can be powered.
ANT A IN ANT A INANT B IN ANT B IN
ANT B IN ANT A IN
TO POWER SUPPLY
ANT B IN ANT A IN
ANT A OUTS
12 VDC POWER CONNECTOR
ANT B OUTS
12 VDC POWER CONNECTOR
AC PWR OUTPUT
AC PWR INPUT
CASCADE B CASCADE A
AC PWR OUTPUT
AC PWR INPUT
12 VDC PWR INPUT
UC4 RECEIVER UC4 RECEIVER
U4 RECEIVER
U4 RECEIVER
U4 RECEIVER
UA845
SINGLE UA845 SETUP
FIGURE 8