Filter
Top Products
ENGLISH
10
P4R RECEIVER
Controls and Features
FREQ
MIX
EQ
LIM
1
2
3
4
5
6
7
8
P4R TOP PANEL
9
1. Balance Knob: This thumbwheel adjusts the left/right balance
when the unit is in stereo and the Mix 1/Mix 2 balance when
the unit is in MixMode.
2. SCROLL Pushbutton: Use with the SELECT pushbutton to
control the functions in the LCD screen. See Pushbutton Con-
trols on page 10.
3. SELECT Pushbutton: Use with the SCROLL pushbutton to
control the functions in the LCD screen. See Pushbutton Con-
trols on page 10.
4. 1/8” Earphone Output Jack: Connects to earphones.
5. Belt Clip: Securely attaches the receiver to a belt, guitar strap
or waist band.
6. LCD Screen: The LCD Screen displays the status of various
functions. See LCD Screen on page 11.
7. ON/OFF/VOLUME Knob: Turn clockwise past click to turn
ON. Continue to turn clockwise to increase volume, counter-
clockwise to decrease volume.
8. Battery Compartment Door: See Battery Installation on
page 10.
9. Antenna: An attached, flexible whip antenna receives radio fre-
quency (RF) from the Transmitter.
Battery Installation
1. Open the battery compartment door by pushing down and sliding towards the antenna.
2. Insert a fresh 9V alkaline battery with the +/– terminals properly positioned.
3. Close the battery compartment door.
Note: If battery compartment door will not close, the battery is not properly inserted.
Set-up
1. Turn the ON/OFF/VOLUME knob clockwise past click (ON).
2. Check the LCD Screen to see if RF is being received. (see LCD Screen on page 11).
3. Plug earphones into earphone output jack. Insert earphones into ears as instructed in the earphone user’s guide.
4. Increase the volume slowly until a comfortable listening level is achieved.
5. Set the desired functions in the LCD screen as described in LCD Screen on page 11.
Pushbutton Controls
Push either the SCROLL or SELECT pushbutton to activate the LCD Screen. Push and hold the SCROLL pushbutton to scroll through
the functions. The current function is underscored. Use the SELECT pushbutton to change the status of the underscored function.
Changing the Reception Channnels
1. Push and hold the SCROLL pushbutton.
2. Scroll to FREQ.
3. Push the SELECT pushbutton to select a channel (0–9 or A–F).
NOTE: Use the same reception channel as the P4T transmitter.
4. Push the SCROLL pushbutton to confirm changes.
Changing MixMode, High Frequency Equalization and Limiter Status
1. Push and hold the SCROLL pushbutton. Scroll to the desired function (MIX, EQ, or LIM).
2. Push the SELECT pushbutton to toggle the function ON or OFF. A function is ON when a dot appears to the right of the function symbol.
3. Push the SCROLL pushbutton to confirm changes.