Shure P3RA Headphones User Manual


 
4
Audio Settings
MODE
STEREO: Audio from channel 1 is heard on the left earphone;
audio from channel 2 is on the right earphone.
MIXMODE: Both channels are heard on the left and right
earphones. The blend between mixes is adjustable.
EQ
The two-band shelving equalizer boosts or cuts bass and
treble frequencies independently (2 dB increments, -6 to +6 dB
maximum cut/boost).
LOW BOOST: 100 Hz
HIGH BOOST: 10 kHz
VLIMIT (Maximum Volume)
Set a value (-3 to -21 dB, adjustable in 3 dB increments) to
attenuate the highest possible volume level. Turning the volume
knob through its entire range of motion still affects volume; the
limit simply narrows the range of dB adjustment.
Note: The VLIMIT does not compress the audio.
BAL MX / BAL ST (Balance)
The behavior of the balance control depends on which mode the
bodypack is set to:
STEREO: Adjusts the left/right balance
MIXMODE: Adjusts the blend between channel 1 and channel 2
Utilities
CONTRAST
Customize the display screen contrast by selecting a setting
between low and high
LOCK PANEL
Locks all controls except the volume knob to prevent accidental
changes to settings
Lock: Select UTILITIES > LOCK PANEL
Unlock: Press the exit button and select OFF when the lock setting
screen appears. Press enter to confirm.
BATTERY
Displays remaining battery runtime (hours:minutes), temperature,
status, cycle count, health, and voltage
RESTORE
Restores bodypack to factory default settings
Note: Applies to SB900 battery only
AUTO OFF
Automatically turns off the bodypack after a selectable amount
of time (5, 30, or 60 min.) while it is in power-save mode or when
connected to a charger with the power on. To restore power to the
bodypack, the power switch must be turned off and then on again.
Note: SB900 batteries charge fastest when the bodypack is off
RF Settings
The RADIO menu contains selectable GROUP and CHANNEL settings,
which are used to manually synchronize the receiver with the
transmitter.
The frequency and band are displayed below the group and channel
settings for reference.