Filter
Top Products
8
MFi Certified
Yes
DSP Modes (Presets)
Speech/Singing/Acoustic/Loud/Flat
Transducer Type
Electret Condenser (25 mm)
Polar Pattern
Unidirectional (Cardioid)
Bit Depth
16-bit/24-bit
Sampling Rate
44.1/48 kHz
Frequency Response
20 Hz to 20,000 Hz
Adjustable Gain Range
0 to +36 dB
Sensitivity
-39 dBFS/Pa at 1 kHz [1] [2}
Maximum SPL
130 dB SPL [2]
Headphone Output
3.5 mm (1/8")
Power Requirements
Powered through USB or Lightning
connector
Mute Switch Attenuation
Yes
Mounting Stand
Built-in
Stand Adapter
5/8-27 thread mount (standard mic
stand mount)
Housing
all metal construction
Net Weight
574.7 g (20.27oz.)
Dimensions
128 x 86 x 70 mm H x W x D
Cable
1 m USB cable, 1 m Lightning cable
[1] 1 Pa=94 dB SPL
[2]At Minimum Gain, Flat Mode
"Made for iPod," "Made for iPhone," and "Made for iPad" mean that an electronic accessory has been
designed to connect specifically to iPod, iPhone, or iPad, respectively, and has been certified by the
developer to meet Apple performance standards. Apple is not responsible for the operation of this device
or its compliance with safety and regulatory standards. Please note that the use of this accessory with
iPod, iPhone, or iPad may affect wireless performance.
iPad, iPhone, iPod, iPod classic, iPod nano, iPod touch, and Retina are trademarks of Apple Inc.,
registered in the U.S. and other countries. iPad Air and iPad mini are trademarks of Apple Inc. The
trademark "iPhone" is used with a license from Aiphone K.K.
Mac
®
and Lightning
®
are registered trademarks of Apple Inc.
Certifications
Specifications
Information to the user
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Industry Canada ICES-003 Compliance Label: CAN
ICES-3 (B)/NMB-3(B)
Note: Testing is based on the use of supplied and
recommended cable types. The use of other than
shielded (screened) cable types may degrade EMC
performance.
This product meets the Essential Requirements of all
relevant European directives and is eligible for CE
marking.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: info@shure.de